Smart control board suitable for 2 small power DC motors drive (600+600W max. peak load)
- Board dimensions (L x W x H): 185 x 100 x 30 mm
- Optoisolated CAN BUS interface equipped with a dual 10 pin Multipole connector;
- Peak and medium load current monitoring and limitation;
- Motor speed control using back-emf voltage reading;
- Motor position control by potentiometer feedback acquiring;
- 5 logic optoisolated inputs that can be used as Enable or End of Span controls;
- 2 logic outputs that can be used as electromechanical brakes controls;
- An on board safety relay protects both motors outputs;
- Logic section power supply: 24V dc;
- Maximum motors drive voltage: 64V dc;
- Automatic generation of Ramp and GoTo facilities;
- Equipped with End of Span SW facility (When motor position feedback enabled)
with in-ramp stop;
- The End of Span logic inputs can be used as manual controls;
- Short Circuit protection on motors outputs;
- All board connections are made with unpluggable wiring blocks;
Click on the image to enlarge (226932 bytes)
This product is available.